Factory Trained
Insured
CT REG #   604290

Clean & Healthy
 Floor Refinishing,
LLC

Beautiful wood  floors with no dust
or toxic fumes 
TM

West Hartford,
 Connecticut

(860) 521-8598

Home The Problem Solutions Photos Contact F A Q Floor Care Links

CENTRAL  CONNECTICUT'S ONLY SERVICE 
DEDICATED TO USING

DUST FREE SANDING & DURABLE, NONTOXIC FINISH MATERIALS
Introduces Clean & Healthy ReVive
™

Clean & Healthy ReVive™ is a convenient, economical, long-lasting way to protect & beautify your floors. It can be used on site finished floors, Pergo-type laminates, and most factory finished wood flooring. Clean & Healthy ReVive™ is a multi-step process that includes: deep cleaning  to remove surface dirt &  stains,  touch-ups  if needed,  and coating with Clean & Healthy ReVive™ finish.   No sanding is required! 
 
Clean & Healthy ReVive™ uses a proprietary coating that  was developed in co-operation with of one of America's finest makers of  wood floor finishes. It is NOT available elsewhere. The Clean & Healthy ReVive™ coating is a genuine commercial-grade polyurethane finish, designed to outlast,  and outperform acrylic and other similar products. Since it is a polyurethane, the process can be repeated in the future,  if necessary. Unlike systems using cheap acrylic materials, it can be re-coated with any other quality polyurethane floor finish. 

IMPORTANT  Clean & Healthy ReVive™ is not for every  floor.  It can help hide light stains and worn spots, but not eliminate them. Light stains, and worn areas can often be touched up to make them less visible. Floors with dark water stains,  pet stains, old paint spots,  heavy scrapes or scratches, will usually require sanding. These issues can be addressed during a free in-house estimate. 

As with all of my services, the
Clean & Healthy ReVive™ system is dustfree, and uses low odor, nontoxic materials.
Before
Notice how dull and dingy the  floor looks.

After treatment the floor is  bright and clean looking.  If you look very closely, you can see some of the imperfections that remained in the floor, but are much less visible.

A typical area where the finish  has been worn by a chair.

The worn areas are hardly visible after the Clean & Healthy Revive system, and the expensive wood is now protected.

Web1bef.jpg (57111 bytes) web1Aft.jpg (50512 bytes) webbef3.jpg (15347 bytes) web3aft.jpg (15765 bytes)
ReVived Kitchen
Farmington
ReVived Dining Room
Simsbury
Bedroom Before
West Hartford
ReVived Bedroom 
West Hartford
xRecoatKit.jpg (73792 bytes) xRecoatDR.jpg (92852 bytes)

xmeg1b.jpg (74660 bytes)

xmeg1a.jpg (68202 bytes)

Worn dingy looking stairs

ReVived
Hundreds of Dollars saved!
Worn, impossible to clean prefinished kitchen floor ReVived
Avoiding  costly replacement
WbefStairs.jpg (79104 bytes) Img_0501.jpg (87638 bytes) 2_22_10 012.jpg (765159 bytes) 2_22_10 018.jpg (457679 bytes)

CLICK ON PHOTOS TO ENLARGE

ReVive™ is

A convenient and economical way to restore the shine to your floors, and protect them..   Easy to care for. 
Fast - An average living room & dining room can usually be completed in one day. Floors can be walked on in hours!
Economical - a fraction of  the cost of sanding and refinishing.   
Durable - ReVive™ finish materials are high quality, commercial grade polyurethanes that hold up to use. 
A perfect way to beautify, and protect older floors that  can not be sanded again.
Suitable for site finished floors, factory finished, Pergo-type laminates, and engineered flooring where sanding is often not be an option.
Very low odor - very low VOC content.  Safe for children & pets.  Completely dustfree.
ReVive™  your floors when they start to look dull ( before the finish wears through), and you may never have to sand and refinish your floors again!

ReVive™ is not

Not a wax or an inferior acrylic product that offers short lived improvements, and causes long term harm.
Clean & Healthy ReVive™ is not a replacement for sanding & refinishing. If your floors have not been finished since  1980, are badly worn, or have dark stains, please consider Clean & Healthy dustfree sanding and Refinishing.
Clean & Healthy ReVive™ is not a do-it-yourself product. It is a professional quality polyurethane finish.

Who Can Benefit from Clean & Healthy Revive™?

Anyone with floors that have been finished  since 1980 who wants to beautify and extend the life of their floors.
Home sellers. Enhance the appeal of your home at a minimal cost by dressing up the floors.  No lingering chemical odors to put off buyers!
Landlords  Protect your expensive floors, avoid the cost of refinishing,  and impress prospective tenants. All for a modest cost.
Active families. When the finish on your wood floors start to show wear, Clean & Healthy ReVive™ can keep them looking good, and avoid sanding.  
Engineered wood floors have a layer of wood that is often too thin to be sanded. Clean & Healthy ReVive™ will keep them looking good, and avoid the expense and grief of tearing them out and replacing them.  
When Pergo-type laminates start to look dull,  Clean & Healthy ReVive ™ can put the shine back.  The alternative is replacing.
Older homes.  The floors on many older homes have been sanded to a point where they can not be sanded again. Clean & Healthy ReVive™  can keep your floors looking beautiful without further sanding. 
Improve the value of your home. 

ReVive™  Q & A

Is there a way I can get an idea of what my floors will look like after the ReVive™  process?
Yes. Take a water dampened towel and rub it on your floor in various areas. Your floors will look fairly similar to dampened areas while there is still a film of water on the floor (before it dries). Keep in mind that the ReVive™  deep cleaning process will remove more ground in dirt than you can, so your floors may look better than after the “water test.”

When should I ReVive™ my floors.
For best results it should be done when the finish on your floors starts to look dull. If you wait until the finish wears through, the floor will not look as good,  and may have to be sanded. 

Is ReVive™ the same as a "screen & recoat"? 
NO. "Screen & recoat" is an outdated process. It creates lots of dust, and removes much of the existing finish while leaving too much dirt behind. 

Will the ReVive™  process remove pet stains, other dark stains or damage?
Probably not. The ReVive™ will remove most ground in dirt, and stains that are on the surface of the floor. Most dark stains have penetrated deeply into the wood. Quite often these stains are so deep they can't be removed by sanding. 

I have some gray areas in high traffic areas of my house. Will the ReVive™  process remove them? 
Possibly. Grey areas are usually caused by dirt and water that has entered the grain of the wood because the finish has worn off.  The ReVive™   cleaning process will remove the dirt, but these areas may still be gray, though  not as dark as before. Spot repairs can often make these areas more closely match the surrounding boards.  A perfect match can not be guaranteed. 
If there are many stained boards, or the stains are large, it is often more cost effective to sand and refinish the floor. 

Will the ReVive™ process fill-in deep scratches, dents, or chips in my floors?
NO. All floor finishes are made to closely conform to the surface of the floor, and not fill in low areas. Deep scratches, dents or chips will  be less visible, but not eliminated. ReVive™ will protect your floors by sealing these areas to prevent dirt and water from staining the wood beneath. Occasionally, chips can be repaired.

Will the ReVive™ process change the color of my floor?
No & YES  The ReVive™  polyurethanes will not change the color of your floors. Although the color of your floors may change somewhat due to the removal of ground in dirt during the deep cleaning process.   Perform the "water test" outlined above to get an idea what the color will look like. 
Sometimes
a small amount of color can be added to the ReVive™ finish to help even out the appearance of the floor and restore its original color.   To achieve a significant color change, it will be necessary to sand  the floor to bare wood, and stain the wood before it is refinished.

How do I care for my floors after the ReVive™ process?
Easy!  Just dry mop or  vacuum to remove dust and grit. Damp mop occasionally. For an extra thorough cleaning, any quality wood floor cleaner can be used. 

Will it take long to do?
NO  In most cases an average living room, and dining room can be completed in one day.  Floors can be walked on with socks, or slippers in a few hours.

Will there be a lot of dust, or a terrible odor?
NO  The ReVive™ process is completely dust free.  I  use only health conscious, low odor, environmentally friendly materials. 

A word about "Sandless Refinishing". Some companies offer what they call "Sandless Refinishing". I feel this term is misleading.  Refinishing requires sanding to remove the old finish and imperfections from the surface of the wood. A floor that has been properly sanded and refinished, can often look like a newly installed floor. While Clean & Healthy Revive™ can greatly improve the appearance of your floors, no system that doesn't require sanding can remove all imperfections from a wood floor, or make them look "just like new."

For more information, or a free estimate, call (860) 521-8598, or use  the form on the contact page.

 

Home The Problem Solutions Contact F A Q Links Photos Care

 

Copywrite ฉ  2011, Clean & Healthy Floor Refinishing LLC  ™